No Scratch Vertical Clamps

Model Number

NVC-HP

NVC-HP (No Scratch Vertical CLAMPs)

[Application]

• The no scratch vertical CLAMPs have no teeth mark after lifting, and are used for manufacturing various tanks that store and transport chemical products.

[Features]

• These devices have a safety latch system. Even when a wire rope becomes loose while you are working, the CLAMPs will prevent the objects you are working with from moving by exerting a CLAMPing force when the springs begin to move.

[How to Use the Product]

• Insert an iron plate into the opening zone of a CLAMP and then close the safety latch..
• Mount the CLAMP on the center of mass so that the gross weight will not be localized or displaced from the center.

[Precaution]

• Remove material (for example, oils, greases, etc.) that may cause slipping on objects, and then CLAMP objects.
• The cams and pads of the no scratch CLAMPs are more easily worn. Thus, ensure to check the worn status of CLAMPs before works.
• Comply with the dimensions stated in the CLAMPs.
• Lift objects only within the range of the jaw opening stated in the CLAMPs.
• Do not lift more than one object with a CLAMP.
• Before lifting objects, check the grasp points and the conditions of the objects to be lifted, as well as whether the safety locking system of the CLAMPs is functioning properly.
• When lifting objects, the signalman must not be within the range in which the objects that are being lifted are rotating. The signalman must then send instruction signals to the crane driver.

Measurement

Specification

Part Arrangement

Components